A compact and discreet dab pen, the Yocan Regen Advanced Concentrate Vaporizer is outfitted with a powerful 1100mAh battery giving you power for long vaping sessions in between charges. You can also find a magnetic connection between the Yocan Regen Advanced Concentrate Vaporizer’s mouthpiece and atomizer base to allow easy and convenient use and operation.
The Yocan Regen comes with a hanging ring.
Below the actual battery, the Yocan Regen is equipped with a 2ml silicone wax concentrate silicone-lined container so you can store your wax concentrates on-the-go.
The Yocan Regen boasts a compact and portable design. This dab pen comes in a simple and minimalistic layout.
The Yocan Regen also comes with three temperature levels that empower consumers and promote further customization of their daily vaping sessions. These temperature levels are now measured and callibrated so you don’t have to guess the voltage level of each profile. Low-temperature settings run at 3.0 volts, medium temperature settings run at 3.5 volts, while the highest setting is rated at 4.0 volts.
Preset Temperatures: 375° F / 390° F / 405° F / 420° F / 435° F
These preset voltage settings were selected to yield result-specific effects. Low temp dabs give you more flavor with thin vapors while high temp dabs give you denser vapors and more potent rips. Vaping in the middle temp gives you the balance between vapor and flavor. Output Voltage: 3V – 4V
Coil Options for the Yocan Regen:
The Yocan Regen Advanced Concentrate Vaporizer comes with two wax coils: A Quartz Tri coil, and the (Evolve Plus) Quartz Dual coil.
The Quartz Tri Coil (QTC) is outfitted with three quartz rods wrapped in high-quality titanium coils. The Quartz Tri Coil ramps up faster than the Quartz Dual Coils and generates more heat in a little amount of time.
The Quartz Dual Coil creates the iconic flavor and vapor production most Yocan dab pens have been known for.
- 1 Regen Unit with Quartz Tri Coil
- 1 QDC (Quartz Dual) Coil
- 1 Dab Tool
- 1 Charging Cable
- 1 Hanging Ring
- 1 User Manual
How to use
The Regen features a design that makes it easy to use, even if you’re unfamiliar with vaping. The first step is to make sure your device is fully charged, the three LED lights near the button should be lit up blue. Next, turn the device on by clicking the power button five times in a row. To adjust your voltage setting, click the fire button three times in a row to cycle between the three settings. I suggest starting at the lowest or the middle setting if it’s your first time, and if you are a seasoned dabber, you might want to try cranking it up to the highest setting.
To remove the top cap, just pull it off. It’s held on by strong magnets, which was one of my favorite features of the Magneto. Make sure the coil is fully installed, and unscrew the coil cap. Using your dab tool, grab a tiny dab of wax, preferably less than 0.1 gram. You can always re-pack it, but overpacking can lead to complications and may shorten your device and coil longevity. The coil cap prevents the oil from splashing and splattering, which keeps the top cap clean. It still works fine without the coil cap, but it will be a lot harder to clean in the long run.
The atomizer portion of the device can be attached to a regular vape mod, which is pretty much all of them. You will have to play around with the power settings, and probably don’t want to go much higher than 20 watts or you might start to wear down the coil faster than necessary. The battery now has multiple voltage settings, and a built-in silicon storage container for dabs.